Big Lego Streamer Flag

Magnified Lego Streamer Flag with Stand and Pole

Here you will find:

• Lego Flag with Stand and Pole.
• (Only) Lego Flag for TP-link router wifi antenna (with smaller inner hole diameter).
• Big Boy Lego bricks (Accessories compatible with the flag).

Dimensions of the Flag itself:

• Length: 80 mm       
• Height: 32 mm
• Diameter of the hole: 8.6mm (Stand with Pole version) and 7mm (TP-link version).

Dimensions of Flag with Stand and Pole:

Print settings: 🖨⚙

• Material: PLA
• Layer height: 0.2 mm
• Wall count: 3 perimeters (0.4 nozzle), 2 perimeters (0.6 nozzle)
• Infill: 30%
• Support: For Flag and Parrot Yes (see main top images), other NO
• Skirt and brim: Use an 6 mm brim for the Pole only
• Print orientation: Same as in .STL files
• Print speed: 30mm/s

ℹ (Note: to zoom in on the  main top images with support settings: Right mouse button --> open image in new tab).


Big Boy Lego Bricks (Accessories for the Flag):
(Note: The Big Boy Lego bricks have a 7mm connector pin radius (14mm then diameter), so you can easily scale up other printable Lego models in Slicer (by increasing the pin radius of regular Lego from 2.5mm to 7mm).

• Bricks: Brick 1x1, Brick 2x1, Brick 3x1, Brick 2x2, Brick 3x2, Play pad 6x3 (not showed on image)

• Business Card holder:

• Parrot: 
  Autor of Parrot: https://www.printables.com/model/1002996-lego-parrot
  Original under license: CC BY-NC-SA
  My edits: Repair of damaged mesh, mesh smoothing, optimization for 3D printing, model enlargement…
  
  ⚠ (Note: Print with support on Parrot neck).

• Flower:
  Autor of Flower: https://www.thingiverse.com/thing:4283065
  Original under license: CC BY-NC
  My edits: Added a cavity to the stems (no filament accumulation occurs during printing), reduced the size and some other mesh adjustments...

A few (older) photos from the preparation:

And now... the WiFi is selected :)