Locomotive Flying Scotsman 60103
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For those that follow, you will be glad to know that I have made this without telling the full build story, as I did…
- Ocena
- 0 / 5
- Polubienia
- 43
- Pobrania
- 615
- Wydruki
- 0
- Wyświetlenia
- 3072
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
For those that follow, you will be glad to know that I have made this without telling the full build story, as I did with the last build.
Hopefully I have learned from my last experience/struggle, (see "S160 Loco"), and there will be fewer issues with this one.
It is designed to be pushed along by a carriage with a powered chassis, because there was no available powered chassis that suited the wheel set up of this magnificent loco that I could find.
I have uploaded screenshots of the model and two for instruction.
I have used the same device as I did with the S160 so that the wheels will spin freely and adjust to corners. This involves a bushing made from 4mm plastic tubing, usually meant for drain pipes and the like, cut into 4mm lengths and split with a removal of a 0.5mm slice. I have included a screen shot showing the wheel/axle assembly using this solution. The other larger drive wheels will need this treatment. The reasons being, the resin does not freely glide against itself or the Peco wheels, a means of holding the axles in place was needed, and this system allows the wheels to drift a little in their housings which is necessary when a long line of wheels go round corners if they are not on bogies.
There may be some embellishments to follow, but I will make them new add-on STLs to avoid annoying people with changes.
Alin.
I hope you enjoy.
Print instructions
Designed to print on Elegoo Mars SLA 3D printer.