Toolbox for Sovol SV02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2 pieces to the toolbox so you can choose to print one or the other
- Ocena
- 4 / 5
- Polubienia
- 12
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 880
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Printed with .24 layer height
Speed 65
temp 115
bed 60
This is the first model I've ever done in my life. I learned how to use blender only so much in about 18 hours of teaching myself how to use it based on what happened when I did certain things. I would say its probably not perfect, but it fits perfect with no wiggle room whatsoever. It was a little difficult to get them side by side because of layer lines but i hit the connecting sides with sand paper for about 10 seconds to make it smoother and they slid right in together. You could maybe shrink it by 1 mm on each connecting side and not have to do that but i didnt want them to have any wiggle room, they are snug as snug gets. The drawers will slide over the feet. (thats the part that was difficult for me to design. took me about 6 hours to figure it out.) You will have to slide them in from the bottom because the screws on top block you from sliding them straight down in. I hope you guys enjoy!
If you download this model and use it, please leave a like and a rating. I would definately appreciate it!
Due to feedback. I remade the right side drawer so you wouldn't have to sand anything and wont cause stress on frame over time. I also beveled the edges around the sd card slot so they wont be so sharp. I hope you like it!