6-inch Irrigation Control Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement cover designed for a 6-inch irrigation control compartment.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
6-inch Irrigation Control Cover
This is designed as a generic replacement cover for 6-inch irrigation control covers. Take note of the dimensions below to see if you need to scale it for your covers as I discovered they aren't always reliably dimensioned.
Key Dimensions
The cover's outer diameter is 153.45 mm (very slightly over 6 inches but this is what it took to properly fit into my control compartment), the inner diameter of the offset is 138.80 mm and its depth is 38.65 mm.
Printing Advice
I printed this with regular PLA with the 0.30 mm layer height draft preset. I printed this because the lawn crew would occasionally destroy one of the covers on accident and this offers a cheap way to replace it, so using the cheapest settings makes the most sense.