Orbiter V2 for Prusa Mini Direct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Orbiter v2 is applied to the direct extruder used in the Prusa Mini Bear.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 1723
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Orbiter v2 is applied to the direct extruder used in the Prusa Mini Bear.
The tube length used in Dragon Hotend is 32mm and the E3D v6 is 48.3mm
The front of the e3d v6 tube should be beveled at a 45 degree angle.
If you use the ADXL345 accelerometer, please use the attached bracket.
Place of purchase Link :
When using firmware 4.3.3 proceed this way to adjust the e-steps value
go to LCD Menu -> Settings -> HW settings -> then long-press the knob.
Scroll down to "Extruder step":
Adjust value to 690.
added to starting Gcode as the mini will not save these settings
;start orbiter settings
M201 E10000 ;acceleration mm/s2
M203 E120 ;max speed mm/s
M205 E5 ;E jerk mm/s
M906 T0 E850 ;TMC motor RMS current in mA
;end orbiter settings
If flashing custom firmware is available, download the attached Mini_Bear_Orbiter_Direct_Firmware.zip file.
NOTE : To use the Prusa filament sensor, download the output file from the link below.
https://www.printables.com/model/267320-orbiter-v2-housing-for-prusa-mini-filament-sensor
- The turbiter was modified referring to the link below.
https://orbiterprojects.com/turbiter/
- The duct was modified referring to the link below.