Seat Back Latch - GM GMC Chevrolet Yukon Suburban Tahoe Avalanche
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I loved the original design, but with my seat backs, the lip was just a little too short to hold up when hitting…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 1055
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I loved the original design, but with my seat backs, the lip was just a little too short to hold up when hitting bumps. And once I started modifying it, I went a little further and upgraded the design a bit! These are pretty easy to replace, just slide the pin out and get these in place! Needlenose pliers are a must.
For printing, print on the side as oriented in the model. Print at 100% fill and you shouldn't need supports. I printed at 0.2mm layer height with zig zag infill. It is very very strong and should last a long time. For heat tolerance, make sure to use PETG, ABS, or ASA.
When you print yours, print out a spare or two just to have, even a couple to give away! Many of these break due to the terrible OEM design.
Category: Other