SKR 1.4 Turbo mount for CR10
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter mount to allow the SKR 1.4 to be mounted on the original CR10 mounting bosses. I wanted stronger fan mount and…
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 556
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Adapter mount to allow the SKR 1.4 to be mounted on the original CR10 mounting bosses.
I wanted stronger fan mount and better bosses for the screws to go into than other designs I tried.
There are two holes for a couple of M3 plastic spacers to be screwed into them to give support the hanging end of the mount, minimising the flap I was seeing on another version I downloaded.
Using this mount you can cut a hole into the side panel of the CR10 case using a Dremel circular cutting disk, allowing the SD card and USB ports to be used in a similar way to the original CR10 board.
I created a bezel to provide a tidy finish to this and make for an easy hole cut.
Bezel design https://www.thingiverse.com/thing:4392864
Update March 2021 - Added a less busy design
Category: 3D Printer Parts