1 / 2
Prop Nut for 1960 Evinrude Lark II 40hp Outboard — zdjęcie 1
1 / 2

Prop Nut for 1960 Evinrude Lark II 40hp Outboard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement Prop Nut for a 1960 Evinrude Lark II 40hp outboard (and similar)

Ocena
0 / 5
Polubienia
4
Pobrania
35
Wydruki
0
Wyświetlenia
222
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Replacement Prop nut for a 1960 Evinrude Lark II 40hp outboard.  This will likely fit similar outboards from around the same time frame.   My local marina was out of stock and BRP (the manufacturer) suffered a cyber attack recently and cannot ship parts, and I was not going to let that o keep my boat of out the water, so here we are. 

I printed in PETG with a .2 layer height with supports on the build plate, with 100% infill, though I don't think this was necessary.  I also printed one at an angle so the layer lines would not be parallel to the shear pin or the cotter pin, but I found the one printed flat to be suitable strengthwise.   

Tagi