Quickmill 02835 - external mount for retrofitted manometer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part is more of a temporary solution for myself and is meant more as an inspiration for an improved design.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This part is more of a temporary solution for myself and is meant more as an inspiration for an improved design.
Installation is as follows:
- install manometer with the fixed capillary tube inside the machine
- route the capillary tube to the top front between the case plates
- put the case with the slot over the tube
- add the printed clamping ring into the case
- slide the manometer in place in front
- with the bracket of the manometer tighten the printed clamping ring towards the back of the manometer to lock it in place (somewhat)
- fix the case to the machine by using some doublesided tape (as said, it's a temporary solution for me :) )
Manometer used: 1245001 for isomac machines.
Print the case oriented laying on the front surface. Use some manual support materials depending on the overhang capabilities of your filament / print settings.
Thoughts for improving the design:
keeping the slot helps with installing the case on top of an installed manometer. But it would be a better solution to implement a tightening solution which tightens the manometer inside by narrowing the slot with a screw-solution or similar.