toilet roll stand with customizable height
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a toilet roll stand with a customizable height. Custimizable because the single rods are available in…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 243
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a toilet roll stand with a customizable height. Custimizable because the single rods are available in different heights (50 mm to 175 mm in steps of 25 mm) so you can choose whatever you prefer (The total height given after the assembly. The single parts can be higher).
The toilet rolls are placed on side arms (largest diameter is 34 mm), which get simply inserted in a connector (picture 3).
The connecting of the rods is done by a compression of small cylinders with a lead-in chamfer. Additionally there are vent holes in the rod for an easier assembly.
If you wish more weight of the stand, you can fill the base with sand. The base (200 mm diameter) is hollow (picture 4). If you fill it, you can rotate the base, so the sand fills the outer areas. At the end you can close it with the base closing chips.
What do you need to print:
- 1 base
- 3 base closing chip if you want to fill the base
- X rods
- 1 lower connector part
- 2 side arms
- 1 upper connector part
The print orientation is shown in picture 5.
Happy printing (No supports needed)!
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2 mm
Infill:
20%
Filament: Das Filament PLA anthracite
Notes:
Printed with 3 perimeters
Category: Bathroom