Foonki Mouthpiece Experiment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
63% scale test so OD tube is 12mm
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 239
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
As an experiment, I cut the Foonki mouthpiece end off Justin White's Foonki model I believe was originally invented by Linsey Pollak and scaled that down to 63% so the output tube OD is 12mm and ID is 8mm. I also made the mouthpiece tube a little longer. This was just to test if it would make sound and possibly still be able to connect a tube to it afterwards.
I printed out of eSun PLA+ in a little over an hour and then cut out a section of balloon and loosely stretched it by hand over the end but so that it was smooth and it was shockingly loud. It sounds a bit like a goose. If I stretch the balloon a little tighter (again with no tape, just held by hand for a quick test) the frequency goes up and is still quite loud.
It definitely works and isn't hard to get a sound out of. Very cool! Thanks for sharing!
I printed at 0.28 layer height and used support. It was a little bit of a chore to dig the support out of the mouthpiece tube so I would next time print with support touching bedplate only.