1 / 7
Owlbert Collapsing staff
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A collapsing staff inspired by owlbert from the owl house
All collapsing staff are roughly 44 inches or about 112 cm long fully extended but that is highly dependent on tolerances of your printer and the model.
Print Settings
Layer height and infill at your discretion, I use 0.3mm layer height and 7% infill
Make sure your line width in cura is set to 0.5mm and extrusion width is set to 0.5mm in prusa slicer for perimeters
Supports are not needed for this model but if used make sure there is not any supports in the model above the rings