Elegoo Neptune 3 Fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A working fan duct for Elegoo Neptune 3.
- Ocena
- 5 / 5
- Polubienia
- 164
- Pobrania
- 1007
- Wydruki
- 21
- Wyświetlenia
- 8127
- Oceny
- 14
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Update October 12th 2022:
Added V2 F3D file for remix.
Update October 8th 2022:
Added V3.
Mounting slots are longer and thicker.
Added ziptie slots for front left fan's wires. I haven't tested it yet.
Update September 4th 2022:
Adjusted duct mounting holes and reinforced fan screw holes.
-------------------------------------------------------------------------------------
Description:
General duct shape was inspired by Mini Satsana Neptune 2 duct fan.
I added a dado and a slot to run cable for the right fan on the inside of the duct.
Screws fit pretty loose for easy adjustment.
- Make sure to position the side ducts above the nozzle tip to allow proper leveling.
Ducts are designed to float 1mm higher than nozzle's tip.
I found overhangs and support detachment needing improvement with the original duct.
The old duct also makes it very hard to see the nozzle and the first layer on smaller prints.
I recommend printing in PETG. I printed in PLA and it works fine.
Block some of the support in the ducts for easy removal. I let it print support 3mm from the edge.
Very easy print. Takes about 6 hours at 0.2mm and 4 hours at 0.3mm.