TFT 50 Mount for JGMaker Artist-D
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had a TFT35 v3 on my other printer and missed it on my Artist-D Pro. I started working on a different mount when I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I had a TFT35 v3 on my other printer and missed it on my Artist-D Pro. I started working on a different mount when I noticed Sebazzz generously included his source file.
There are two mounts, The original was designed to mount to the power supply screws on the left side of the case. You'd need two M4 x 20 screws for this.
The other mount is a magnetic mount. It also used the power supply screws, but only to locate. For magnets use two 8x3 mm magnets for each hole. I recommend doing the top and bottom holes and use the middle holes if you need them.
You'll also need longer cables to connect your display and, unless you want to cut a hole in your case, you'll need to disassemble one end of the connector, thread it through a vent hole, then redo the connector end.
Note: Tested with my Pro. Let me know if the PS mounting screw is different for the base version.
Update 7/24/2021: Moved the brace for the mounts to the top, to better hide the wiring.
Links: 10 Pin Female to Female ribbon cable 5 Pin Female to Female ribbon Cable
Print Settings
Printer:
JGMaker Artist-D
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
20
Filament:
eSun PLA+
Purple
Notes:
Use 4 outer layers for strength
Mount shouldn't need supports, but if you choose to print the touchscreen front open side down (like I did), maybe with ironing, which will take about a hour longer, you'll need supports.Category: 3D Printer Accessories