1 / 10
Fan duct for BMG Aero Wind/Bondtech BMG Mount (JGMaker Artist-D) — zdjęcie 1
1 / 10

Fan duct for BMG Aero Wind/Bondtech BMG Mount (JGMaker Artist-D)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a part-cooling fan duct for my BMG Aero mount for JGMaker Artist-D AND the BMG Aero Ender-3 / CR-10 mount by…

Ocena
0 / 5
Polubienia
4
Pobrania
31
Wydruki
0
Wyświetlenia
589
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a part-cooling fan duct for my BMG Aero mount for JGMaker Artist-D AND the BMG Aero Ender-3 / CR-10 mount by Adolf_Muffin that my extruder mount was remixed from. Both were generous enough to post their step files or my things would never have happened.

Should flow air better than original, BUT will require my updated BL Touch mounts, since this fan has a bigger foot print.

Print fan duct with supports with bottom flat side down. M3 hardware needed to attach to mount.

Print the duct with PETG and supports. The mounts can be printed in PLA if you prefer.


Update 4/15/2021: I extended the fan duct mount even lower to allow the bottom hole to be used with a volcano hot end. (v6) Enlarged the holes on the BL Fan and BL Touch mounts to work better with M3 screws.

Update 4/17/2021: Added BL Touch mount for Bondtech BMG extruder, which has no cooling fan.

Update 4/18/2021: Updated the Bondtech BL Touch parts and fixed the BL Mount for 4020 fan, which was offset the wrong way. Renamed the Bondtech parts to be similar to fan counterparts.Probe Offset will be -30.508, -27.713 for all variations. Z-coordinate will vary with Bondtech, Volcano, v6.

Update 4/20/2021: Added an experimental fan duct for opposite side.

Update 4/30/2021: Added version 2 of fan ducts that sit a bit more vertical.

Update 5/16/2021: Added updated versions of the fan and no-fan mounts with more screw holes and BL Touch mounts are beefier.


Print Settings

Printer:

JGMaker Artist-D Pro

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

100

Filament:

eSun PLA+

Purple.

Category: 3D Printer Extruders

Tagi