Ball Joint for Skip Hop Baby Backseat Car Mirror
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A larger ball joint that has a tightening feature and fits the Skip Hop Baby Backseat Car Mirror.
- Ocena
- 4 / 5
- Polubienia
- 20
- Pobrania
- 118
- Wydruki
- 1
- Wyświetlenia
- 811
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi 3D printing friends! This is a ball joint that fits the Skip Hop Baby Backseat Car Mirror. The ball is larger and more sturdy than the one that comes with the mirror, and has the ability to tighten and clamp down on the ball so it won't move or shake from its intended alignment.
I printed this in PETG at .15 layer height, 30% infill, and 5 walls (overkill likely, but was very sturdy).
The screw and nut locations were sized for a 5mm hex head screw that is about 1.5 to 1.25" long. I used a nyloc nut as shown in the images which worked well.
Note that on the PRUSA MK3s+ the standard ball below worked well for the fit, but I also included two larger ball versions (+.010" and +.025") since the Bambu Lab X1 Carbon seems to print the ball slightly too small and not to scale when using PETG.
Enjoy, and please share your makes!
Links to Mirror: