Miniature Painting Stand & Handles
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple paint stand, with handles, for batch painting miniature figures such as Bolt Action, 40k, or DnD.
- Ocena
- 5 / 5
- Polubienia
- 176
- Pobrania
- 528
- Wydruki
- 10
- Wyświetlenia
- 4203
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Based off the paint stand by spikedsynapse, which I quite liked, I've been finding that the 4x4 arrangement is too cramped. When doing batch painting of a unit, more than a few times I've brushed a finger against one figure while grabbing another, with a resultant smudge. Spacing them out in an alternating pattern fixes that, but meant a lot of wasted space.
As such, I took the existing model and reworked it to have more space between the slots. Even my fat fingers can easily grab a stand without hitting another one! With the extra spacing though, I reduced down the size from 4x4 to 4x3, which is still sufficient for most unit sizes if you're batch painting for something like 40k or Bolt Action. There is also a 4x1 version to supplement if you need more space, or are doing a smaller batch.
Two versions of the handle are also included. One is just the original design, unaltered, with a flat top. You can use BlueTac or similar to keep figures attached. I also have experimented with magnetizing the handle, with a hole for a 10x2mm magnet to be superglued in, if you are using magnetized bases on your figures. In the end I think I probably prefer BlueTac, but YMMV, so both are included.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Filament: Prusament / Amazon Basics PLA
Notes:
Have made with several PLA brands, all work fine. It is a very easy printing design.