StreamDeck XL M8 mount for Profile
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
StreamDeck XL mount for my Sim Rig
- Ocena
- 4,667 / 5
- Polubienia
- 35
- Pobrania
- 279
- Wydruki
- 3
- Wyświetlenia
- 3446
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a magnetic mount for the StreamDeck XL that fits the StreamDeck like the included factory mount. It uses two M8 bevel head bolts to mount it. There is a hole for the USB port in the center.
There are holes for 5x2mm neodymium magnets that I used super glue to hold in place. Make sure to verify the polarity matches the underside of your StreamDeck before applying the magnets. I used a red dot to signify up when I installed mine. You will have to install them one at a time and allow the glue to dry so the magnets don't pull together.
I'm using corner brackets bolted to the sides of a piece of 40x40 profile allowing me to tilt the StreamDeck XL while giving it a very RIGID mount.
When I added full rig motion, I added a bit of non-drying window caulk for good measure and while I can still remove my StreamDeck, it has not come loose during heavy movements and haptic effects.
This is a remix from the link below, but I couldn't find a way to publish this with that checkbox checked.
https://www.thingiverse.com/thing:4884409