Frameless Picture Hanger Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount foam board art to your walls without a frame by glueing these prints to the back.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 604
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Share Alike
Print two of each, clean and sand the flat back pieces of each and glue onto your piece of art. In my case, that was a print on a plastic sheet (I think it's a dense polystyrene foam, but I'm not a hundred percent sure.)
The small pieces are meant to support the bottom so it sits parallel to the wall, otherwise the bottom would touch the wall while the top of your art would be approx. 1 cm away from the wall.
After the glue has fully hardened, all you need is two nails in the wall, ideally level. 😁
I personall used J-B Weld two-part epoxy, but I think that may be overkill. Printed using white PLA, 20% infill, in my case.