Adimlab Gantry Z Stepper Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An additional mount bracket for the Z motors on the Adimlab Gantry printer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
An additional mount bracket for the Z motors on the Adimlab Gantry printer.
Hardware:
2 M3 x 12 screws for the motor
2 M4 x 8 screws to mount on the 2020 extrusion
2 M4 t-nuts
Install:
Put M3 screws in
Put on motor and start M3 screws
Push t-nuts into the extrusion and align with hole
Carefully install M4 screw and get started in t-nut
Tighten all screws, but be careful not to overtighten
Print Settings:
Infill: 35% Cubic
Filament brand: Your Choice
Filament material: PLA + or filament of your choice
Notes:
Print with the flat part on the bed (The part that after printing will be at the back of the printer).
Recommend 5 walls, 0.28 layer height, and 35% cubic infill at 60 mm/sec. Took 1 hour and 4 minutes to print.
Support is not needed, but can use for screw holes if desired.
Also, recommend printing the OEM bracket with these settings.