Badger Cover for Pimoroni Badger 2040
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple cover for the Pimoroni Badger 2040 that doesn't obstruct any connections
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 91
- Wydruki
- 1
- Wyświetlenia
- 1282
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A cover for the rear of the Pimoroni Badger 2040. This covers up the exposed electronics on the board but doesn't prevent access to the ports, buttons and connectors on the rear. It requires screws to attach, but doesn't stick out any further around the sides of the Badger 2040 to make it any larger than it needs to be (and because my attempt at push-fit pins didn't work out). Doesn't stick out further from the rear than the JST-PH power connector.
Two versions of the model included, one with smaller holes for screws and nuts, one with larger holes for heat-fit threaded inserts. No supports needed, but some bridging for the rear of the strap hole (it's recessed from the rear to help with centring and so it's not too thick for clips). Thicker on one side to help with balance, but not on the outside face.
Bill of Materials
- Pimoroni Badger 2040
- M2 hardware, either:
- 4x 6mm long screws and 4 heat-fit threaded inserts, ~4mm long and 3.5mm outer diameter.
- 4x 10mm long screws, 4x nuts, 4x washers
Print and assemble. Shouldn't need supports but there is a bit of bridging.