1 / 1
USA 3-hole | 15mm | RC3 | ear flare | face shield — zdjęcie 1

USA 3-hole | 15mm | RC3 | ear flare | face shield

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of Prusa's RC3 face shield with: USA 4.25" 3-hole punch spacing (1/4" or 6mm holes) 15mm z-height (quicker…

Ocena
0 / 5
Polubienia
0
Pobrania
276
Wydruki
1
Wyświetlenia
1169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
BSD License

A remix of Prusa's RC3 face shield with:

  • USA 4.25" 3-hole punch spacing (1/4" or 6mm holes)
  • 15mm z-height (quicker print with minimal impact on durability)
  • improved comfort near ears via 7.5° flare
  • filets instead of chamfers to reduce fabric snags
  • simplified rubber band hold
  • no logos

v2.1 update:

  • Mounting posts updated
    • post spacing corrected
    • optimized for pre-punched overhead projector sheets OR manual 3-hole punch with circular holes
    • posts have ridges at the tip to prevent thin plastic from falling down
  • Comfort
    • 165mm model added for better fitment on smaller heads

v2.2 update:

  • rubber band holder updated to prevent band from falling off when face shield is not in use.

v2.3 update:

  • step file added
  • mounting posts widened by 0.5mm to improve fitment for larger sheet holes

Print instructions

For Mk2.5 and later (Mk2 OK too, but slice your own gcode!)

Standard PETG 0.4mm nozzle profile is OK but here are some optimizations for print speed without bumping extruder beyond 240 degrees and ruining quality:

  • layers & perimeters
    • 0.25 layer height
    • 3 bottom and 3 top layers
  • speeds
    • 70-90 mm/s inner perimeter speed
    • 60-80mm/s outer perimeter speed (depending on printer tuning, there may be surface ghosting which won't affect durability or comfort)
    • 60-70mm/s gap fill (most "gaps" are long stretches between perimeters so this won't vibrate the printer unlike other models)
    • 100-200mm/s infill
  • infill
    • 15%
    • gyroid interior, rectilinear top/bottom
  • advanced
    • 0.5mm first layer extrusion width (improved bed adhesion)
    • 0.6mm infill (speed)
    • 0.5mm solid infill (speed)

Tagi