Link collection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you want to customize your Bags even more, here are some different shaped links for your new Body strap. No TPU
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Introduction:
If you want to customize your Bags even more, here are some different shaped links for your new Body strap.
Every Link fits every other, this makes for endless possibilities!
If you do not know my Bags, here is a link to all of them:
https://www.printables.com/social/29398-magda-j/collections/254916
No TPU, no Support, just 0.2 mm layerhight and 10 percent infill in PLA or PETG. For assembly 1.75 mm Filament is cut to length.
Assembly:
Tools required:
For assembly the following will be needed:
- About 1 meters of PLA 1,75mm filament
- Pliers to cut the Filament
- Ruler
- Pin or needle (To undo if you made a mistake)
The Body strap is a repetition of the following steps: First cut filament to 1,8cm and then insert it in the next Link, to connect the pieces. There is on one side a small and on one side a big hole, when you push the filament in.
You will have noticed that there is one side with a smaller hole which the filament does not fit. This is for undoing purposes. Just insert a needle (or anything small and pointy) and then grab the filament on the other side and pull it out.
This is how every connection can be undone.
Final thoughts:
Please let me know how your experience with these links is. I hope you enjoyed it. If there is anything you would like to see changed, please comment and I will reply.
At last, I would like to see your bags, so please post a make and earn some prusameters :)