Ender 3v2 Shallow Tray For catching "bits" and "strings"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vslot covers are nice to keep your 3v2 clean, but the base still gets covered in bits and pieces of junk. This helps!
- Ocena
- 5 / 5
- Polubienia
- 44
- Pobrania
- 254
- Wydruki
- 1
- Wyświetlenia
- 1524
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pretty straight forward build for keeping your print area cleaner. The amount of small bits of plastic that comes from printing is aggravating. Vslot clovers are nice to keep that area clean, but the whole printer gets dusty and covered in strings and such.
This tray prints in 2 pieces for the trays, then print 2 of the “3 hole slot guides”. The slot guide prints separate to avoid all supports. Hot glue or super glue them in after printing. They are a tight fit and I did not need glue. The vslot guide is not a t-track. It just helps keep the tray in place. These trays easily lift up to allow dumping of the contents. (picture shown with endcap removed for easier understanding)