Guitar Pick Holder Capo Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip on Guitar Pick Holder for Tiger capo (or similar clones). Holds 3 picks clipped to capo.
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 167
- Wydruki
- 1
- Wyświetlenia
- 1406
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Clip on Guitar Pick Holder for Tiger capo (or similar clones). Holds 3 picks clipped to capo.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.1mm
Infill:
20%
Filament: prusament PLA galaxy grey
Notes:
print with pick slots vertically - no supports needed. 0.2mm print is probably fine, but may require some cleaning up of the slots
If clips are too stiff, soften part with hair dryer (PLA).
Pick holes work well for my 0.7-0.8mm picks straight off the printer.
If too loose, heat-soften the part, place your picks in the holder and squeeze between fingers until cool. Easy enough to widen with sharp knife but should not be needed
Category: Music