1 / 8
Cantilever "Claw" Clamp
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Re-engineered version of the maximal or cantilever clamp with a unique drive system to deliver high clamping forces
- Ocena
- 4,833 / 5
- Polubienia
- 254
- Pobrania
- 518
- Wydruki
- 7
- Wyświetlenia
- 4568
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 7) (Komentarze: 19)Remiksy (0)Kolekcje (392)Powiązane
This is a high gripping force clamp configuration (relative to other FDM versions) that was re-engineered to included the following features
- Triangular Cross-Section Threaded Drive Rod. This insures the drive rod is always centered in the treaded fitting while allowing a large contact area with the print bed. This design increases strength and lower material use and build time compared to vertically build threaded rods.
- Capture mechanism designed into the reaction bucket so the jaws open and close automatically with the drive rod rotation. The original design required the lower jaw be manually opened.
- Reduced number of external retention parts by 60% via incorporating internal capture features in the jaws. The design only requires two external pegs to secure the threaded fitting into the upper jaw.
- Reduced material use and build time by re-designing the jaws to use stiffeners where loads were applied or re-directed.