Parallel Gripper for EEZYbotARM MK2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of my Rov Manipulator (Parallel Gripper) modified to fit the EEZYbotARM MK2 robotic arm and be…
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 585
- Wydruki
- 1
- Wyświetlenia
- 2652
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of my Rov Manipulator (Parallel Gripper) modified to fit the EEZYbotARM MK2 robotic arm and be controlled by a servo instead of a rotating shaft.
Use a SG90 Servo
Hardware required (See pictures for screw layout.) All screw holes are pre-tapped
(4) 2-56 x 1/2" screws
(2) 4-40" x 3/8" Button Head Screws
(2) 4-40 x 1" Flat Head Screws
Servo Mounting screws.
Some of the parts will need to be oriented to be printed properly. See pictures for the layout I used. The fingers, forward hinges, and Pad need to be printed x 2. The finger pads were printed in a flexible filament for better grip but can be cut from rubber.
See https://www.theneverendingprojectslist.com/raspberrypiprojects/raspberrypiroboticarm/ for more info.
Category: Robotics