Raspberry Pi Case for 3D Scanner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover for Raspberry Pi 3D Scanner (PiClop) that runs FreeLSS scanning software (http://www.freelss.org/), a derivative…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 280
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Cover for Raspberry Pi 3D Scanner (PiClop) that runs FreeLSS scanning software (http://www.freelss.org/), a derivative of the Atlas 3D Scanner.
You can order PCBs for the scanner from OSH Park - see https://oshpark.com/shared_projects/FvgkGJDE
The Piclop cover has been redesigned to work with Raspberry Pi Scanner HATs that can be found at https://www.tindie.com/products/9884/
The Raspberry Pi bottom mount is from https://www.thingiverse.com/thing:1466385
For more information, see https://github.com/electronlove/3D_Scanner
Print Settings
Printer:
Custom Delta XL
Rafts:
No
Supports:
Yes
Resolution:
200 micron
Infill:
50%
Filament:
Inland PETG
Green
Notes:
Print on side to improve strength of tabs for both scanner cover and bottom mount for scanner otherwise the tabs are more likely to snap off as they are thin.
Print slowly at ~ 50 mm/sec with supports.The Raspberry Pi bottom mount only has two screw holes but should have four.
Category: DIY