Coin and key tray with inlay for Ridge Wallet/Slot type card wallets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple cointray and inlay for slot type wallets. Fits Euro coins and standard keys. Takes up 4 card slots/spaces
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 437
- Wydruki
- 2
- Wyświetlenia
- 2686
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made a simple coin/key tray for my Ridge wallet, but I also tested it with 2 other slot type card wallets, one with friction fit and one with a slide out lever and it works with all of them :)
It's about the same dimensions as the original(86mmx54mmx3.5mm), just a bit thicker to accomodate the flexible nature of thin PLA. It takes up 4 credit card slots(ie its as thick as 4 standard cards). Made to fit Euro coins and standard(at least in germany) house keys. Height of the “cavity” is 2.5mm without the inlay, 2.3mm with the inlay in place.
Also designed an inlay to be printed out of TPU/other flex material. Clearance for the inlay should be fine(about 0,1mm, worked fine with my test print). If it's too tight, just scale it down a bit or tell me and I can make an updated version.
Printed the tray with 100% infill to reduce flex for the tray as much as possible and 0.2 layer height. Also used ironing to get a nice flat surface
The inlay can be printed in vase mode(as its only 1 layer/0.2mm thick), however I printed it with 0.1mm layer height and 0.1mm first layer to get 2 layers as the bottom.