Neje Air Assist (30W)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Neje 30W laser module air assist. (for 40W module see https://www.thingiverse.com/thing:5194498) It's a very compact…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 196
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
A Neje 30W laser module air assist. (for 40W module see https://www.thingiverse.com/thing:5194498)
It's a very compact one which still enables access to the focus ring.
There are two versions with a 4 and 6mm inner tubing. Both are intended for the hose to be inserted and glued with a bit of superglue.
This way it stays super secure and there is less chance of mounting pipe to break as it is touching the mounting plate.
I also provided the "quick connector" to be connected directly to compressor that I have (Stanley Fatmax Silent 101) which is also to be glued in the same way. This is all to ensure these pieces are thick and can hold pressure.
Note, since we are talking about plastic don't use this for high pressure (I do use this with 30 PSI which I would say is way above what you should be doing with plastic prints like this) as this could all explode. In any case print this very hot with maximum walls and in ABS. You have been warned.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
100
Filament: Jupiter 123-3d.nl PLA
Category: DIY