55 mm Kitchen Sink Strainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kitchen Sink Strainer for 55 mm sized holes.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 141
- Wydruki
- 0
- Wyświetlenia
- 638
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Summary:
I really liked LoboCNC's sink basket strainer (https://www.printables.com/model/132291-sink-basket-strainer), but my sink was not standard (I think) so I made my own model from scratch. This should fit sink drains of a diameter of 55 mm, but you can scale it as fit. The “net” to stop particles is made via slicing.
Slicing instructions:
There's two models available. The .stl it's just the model without any additions, and the .3mf includes my slicing modifications. I added a prusaslicer modification cylinder of the same size of the internal shape (54 mm - 2 * 1,6 perimeter walls) and removed top and bottom layers, to ensure an infill net is created. I used 30% triangle infill, but you can use whatever you like.
If you resize the model, just bear in mind that you will need to change also this.
Considerations:
- I recommend using PETG instead of PLA to ensure that hot water can't deform it, but either material will work anyway if you don't put anything hot over it.
- Support is necessary, but it's easy to remove and doesn't need a lot of it, you can use PrusaSlicer snug supports.
- I also recommend not going up 40% infill, because although the small triangles look very cool, it will clog in no time and foam has a hard time passing through it. Any 2D infill will work very good.