Spraycan holder (No rattle and side movement)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holder is for service trucks and general mechanic application on the move.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 258
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
There are many can holders out there but many of them is not usable for mechanics on the move because they do not “hold” the can and stop it from ratteling around in the car / truck.
note there is a small recess on the backside for dubble sided tape its more easy to line several up before self tapping screws ect.
Motorsport service trucks and van life will love this holder.
Will also fit some pegboard systems 100mm between holes
Printing (See below for update): PETG and 0.4 nozzle and 0.2 layers , keep walls to a maximum around the “ears” of the holder (weakest point) and most settings will be fine. UPDATED !
Update: I have tested with Spectrum ASA 275 and printed in 0.3 layers and printed in standing orientation with minimal “Snug” support it works very well and are near perfect every time and support comes off easy, print time is just over 6 hours.