Steam Deck Vesa Mount

I have an adjustable monitor stand with two Vesa Mounting-Points, but at the moment, only one monitor. Since I often use my Steam Deck as a Desktop, I decided it would be funny if I mounted it on the stand as well. So, I made this little Vesa Mount specifically for Steam Deck.

With this mount, you have access to all ports, including SD-Card, as well as enough space for the cooling on top and on the back.

You also need some screws: 4x M3 6mm - 20mm and 4x screws to attach it to the Vesa mount. (I used old screws i had laying around from Ikea for this)

NOTE!
I printed everything (except the Vesa mount itself) in TPU, so it might be a different experience if you print it with PLA.

Now to the “Problems”:

The top part of the holder is a pain to get perfect. I have already made three versions of the top part and I'm making a fourth one, because each one has different problems (but all of them work).

V 1.1: It was too loose, and you could slide the Steam Deck around inside (but it still stayed inside).

V 1.2: It doesn't slide anymore but now it is a bit too tight, so you can't reach the ports when you fasten it (except if you push it a little harder).

V 1.3: I am combining the best of both, but: now it is still a little too loose. and the ports are not perfect centred.

V 1.4 This one is perfect (in my case). it's not too loose and not top tight. all ports are perfect centred, and you can reach all of them without any problem.

I still leave the other versions online because it could be that it varies depending on the settings, printer or materials you use.