Kingston King Drive 5:1 USB Drive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's a massive flash drive, it will probably only fit in a huge USB port, I bet you could find that here too.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 806
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This is a modified and split version of a Kingston USB flash drive originally found on GrabCAD designed by Jeff Miller. After creating a 5:1 scale model of a USB port, I knew something had to go inside, and that something had to be a massive USB drive. I also found that inserting this into the massive USB port caused the pins to break, so there is an updated pin model on that page.
I printed this with PLA, I highly recommend using something more flexible and strong like PETG. No glue is required, this model should friction fit itself.
Print Settings:
- PLA or PETG (really anything slightly flexible)
- 0.2 layer height for Shell and Tray
- 0.2 layer height for pins
- No Supports except for the keyring if you're worried about the overhang at the top.
- Try printing the pins at 1% less scale than everything else so they fit better.
- The tray may require sanding of the sides to fit without bending the shell.
Good luck and enjoy the model!