Low Friction & Better Overhang Propeller (TPU-friendly) for Wind-up Boat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The original propeller had a 20-deg overhang, which made it difficult to print without support, or with TPU.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 182
- Wydruki
- 2
- Wyświetlenia
- 1509
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
The original propeller had a 20-deg overhang, which made it difficult to print without support and brim, or if one wants to print with TPU.
The original shaft also has too much contact area which increases friction.
I wanted to print this propeller and its shaft in TPU so that it will never break and never hurt my fingers, but the original overhang was just impossible for TPU. So I designed this new propeller to be printed without support.
Recommended Filaments:
PETG: https://amzn.to/45juHZv
TPU 72D: https://amzn.to/4l08AMi (for indestructable strength, can print on Bambu AMS)