Planetary Gear Spinner

Thing in action: https://www.youtube.com/watch?v=k8eqPtJBss0

This is a planetary gear spinner with the planet gears able to spin around the sun gear. Gears inherently add friction to the system so the spin time is less than most spinners.

Each gear has module of 2.0, 15 teeth and a 20 degree pressure angle and a backlash of 0.5 mm to allow the gears to spin freely with my print settings. Ideally backlash would be zero. If you would like to fine tune the backlash, you can do so using Fusion 360's Spur Gear add-in and regenerate the gear with less backlash. However, it is important to keep the module, pressure angle and number of teeth the same.

Edit:
If you're having trouble with the press fit of the planet gear bearings to the planet carrier, there is now a version 2 that has a modified planet carrier with pins that will keep the planet gears from falling out if the press fit is too loose. These pins can be glued in place

Edit: I made a version 3 that does not require bearings but instead utilizes self contained slider bearings. Not as good actually ball bearings, but they spin surprisingly well.

Required Hardware: 4 x 608 bearings.

Parts to Print:

1 x Planet Carrier
3 x Planet Gear
1 x Sun Gear
1 x Thumb Component

Parts to Print for version 2:
1 x Planet Carrier v2
3 x Pin to Hold Planet Bearing
3 x Planet Gear
1 x Sun Gear
1 x Thumb Component

Parts to Print for version 3:
1 x Planet Carrier wSliderBearing
3 x Planet Gear wSliderBearing
1 x Sun Gear
1 x Thumb Component

You will need to print the planet carrier with support. I tend to print it in the orientation it is set, but you could try printing it flipped so that side you see is cleaner.