Aixun T3A Solder Station Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Designed to be printed @ 0.2mm layer height with 0.4mm nozzle. I really like my new Aixun T3A solder station but the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Designed to be printed @ 0.2mm layer height with 0.4mm nozzle.
I really like my new Aixun T3A solder station but the only small negative, if you can really call it that, is the fact that the unit sits flat on a desk and makes reading the screen a little more difficult than it could be.
This is why I printed basic wedge just to raise the front of the unit up a little.
I have also added slightly recessed areas for the units original rubber pads to locate for stability (hopefully they are consistent across all units).
I would also suggest adding some rubber pads to the base of the wedge to stop possible sliding around.
Happy Printing ;)
Category: Electronics