1 / 1
15mm thin | USA 3-hole | ear flares for comfort
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of Prusa's RC3 USA 3-post face shield with: 15mm z-height vs 20mm for Prusa's (quicker print and 25% less…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 239
- Wydruki
- 0
- Wyświetlenia
- 739
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
A remix of Prusa's RC3 USA 3-post face shield with:
- 15mm z-height vs 20mm for Prusa's (quicker print and 25% less material with minimal impact on durability)
- improved comfort near ears via 7.5° flare
- filets instead of chamfers to reduce fabric snags
- optimized for pre-punched overhead projector transparency sheets with elongated outer holes OR manual 3-hole punch with circular holes
- posts have ridges at the tip to prevent thin plastic from falling down if holes are not the exact size of the posts
- no logos
Print instructions
For Mk2.5 and later (Mk2 OK too, but slice your own gcode!)
Standard PETG 0.4mm nozzle profile is OK but here are some optimizations for print speed without bumping extruder beyond 240 degrees and impacting quality/reliability of prints:
- layers & perimeters
- 0.25 layer height
- 3 bottom and 3 top layers
- speeds
- 70-90mm/s inner perimeter speed
- 60-80mm/s outer perimeter speed (depending on printer tuning, there may be surface ghosting which won't affect durability or comfort)
- 60-70mm/s gap fill (most "gaps" are long stretches between perimeters so this won't vibrate the printer too much)
- 100-200mm/s infill
- infill
- 15%
- gyroid interior, rectilinear top/bottom
- advanced
- 0.5mm first layer extrusion width (improved bed adhesion)
- 0.6mm infill (speed)
- 0.5mm solid infill (speed)