ANYCUBIC VYPER - Nozzle wipe brush and Zendstop

I designed this mod to allow me to use the function in cura to clean my nozzle during printing ,when I was printing with PETG which tended to buildup during a long print around the nozzle enabeling nozzle wipe in cura removed this build up with my design fitted.

This mod replaces the right hand endstop trigger and has a brush sitting over the trigger that holds 2 wire brush sections to run your nozzle through at layer changes and stop the accumulation of PETG boogers that get stuck to your print.

you will need on small wire brush that you cut the head from and then cut in half, one for either side of the new brush holder.

https://www.amazon.co.uk/Sourcingmap-a13080200ux0296-6-9-inch-Plastic-Bristle/dp/B00H4Z02LQ/ref=sxts_rp_s_1_0?content-id=amzn1.sym.997bd184-e71e-4447-bef9-c5495ae8a098%3Aamzn1.sym.997bd184-e71e-4447-bef9-c5495ae8a098&cv_ct_cx=wire+brush&keywords=wire+brush&pd_rd_i=B00H4Z02LQ&pd_rd_r=17ad7542-096f-409e-88ec-4418a354f94c&pd_rd_w=ZS992&pd_rd_wg=cboRj&pf_rd_p=997bd184-e71e-4447-bef9-c5495ae8a098&pf_rd_r=FE36CH1DS53A77TGGF40&psc=1&qid=1663964944&sprefix=wire+%2Caps%2C76&sr=1-1-1890b328-3a40-4864-baa0-a8eddba1bf6a

link to amazon for brush.

You will need to cut the head from the brush and then cut the seperated head in half, one for each of the brush openings. the two pieces should be around 18mmm, any bigger and you may need to shave them down to fit.

please print in the orientation shown in the rendered image and you will need to set supports to everywhere to get a decent print that accepts the brushes.

Thanks for looking at my mod