Handles for Medela Baby Bottle

I remixed Drizzt's (thingiverse 4079137) model because it was too tight and the lid was not closing properly, resulting in milk leaking.

Also made the handles longer and closer to the bottle for a more comfortable fit.

On some bottles it does spin a bit if the lid is not strongly tight, not a problem for the baby as the bottle round.

I printed it at 0.2mm layer height and it was perfect, no need for supports but i suggest to do at least 3 perimeters and 30% minimum infill.

3D printing is inherently risky when it comes in contasct with food and especially babies as the layers leave some gaps in between, remember to give it a little rinse and dry after every use to avoid mold. If you print it with a little more flow or/and with inter-perimeters distance a bit less than 100% could help fill those gaps.