Skådis - MagSafe Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your iPhone charged and safe from your workstation
- Ocena
- 0 / 5
- Polubienia
- 61
- Pobrania
- 259
- Wydruki
- 1
- Wyświetlenia
- 2262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Disclaimer:
This model use @Xuis delightful Skådis T-Clip System, go check his page!
What is this?
This model allows you to put your iPhone out of reach of incident and charge it.
Depending on the placement you can also use it to display handy information, watch video and listen to music/podcast.
I've used this model of MagSafe charger off amazon, which while not official is the exact same side as the Apple one.
Assembly instruction
Everything is press to fit, with a tight tolerance (0.12mm for the part holding the charge, and 0.mm for the part holding the Skådis peg).
I will upload more version tomorrow for various printer tolerance.
You just need to print one T-Clip and one MagSafe holder.
Before putting your MagSafe Charger you should insert the T-Clip in the Holder like this:
Then you just need to put your MagSafe Charger in the holder and secure it to your Skådis pegboard!
Enjoy!