Wiha Convertible Screwdriver Skadis Pegboard/Freestanding Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Wiha Screwdriver holder that can be removed from the Ikea Skadis pegboard and stand on your bench.
- Ocena
- 0 / 5
- Polubienia
- 255
- Pobrania
- 197
- Wydruki
- 0
- Wyświetlenia
- 5391
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Details
This is a Wiha screwdriver holder I designed to lock onto a French Cleat on your Ikea Skadis pegboard, or with the push of two buttons, can be removed to stand freely on two legs that fold into the sides.
For the pushbuttons I used springs 8mm in diameter and about 8mm long that I had laying around, and screws from an old hard drive that are 2-56 by about a half inch long. These are screwed into a heat set insert melted into the pushbutton. 
This model also uses T-Nuts for Ikea Skadis Pegboards by user 6d6178 to attach to the Skadis. The hardware for that is included below, but you'll have to download the models from them.
It needs the following heat set inserts
QTY 2 - 2-56
QTY 2 - M3
QTY 6 - M2.5
It needs the following hardware
QTY 6 - M2.5 x 12mm screws
QTY 2 - M2.5 x 25mm screws (for the T-Nut)
QTY 2 - M3 x 10mm screws
QTY 4 - M2.5 Washers
QTY 2 - M2.5 Nuts (for the T-Nut)
It uses three 6x3mm magnets to hold the screwdriver kit.
I've included the step file so you can customize the middle support plate if you want.
Print Instructions
I printed in PLA at .1mm layer heights and supports where needed.