X5SA PRO 2040 Brackets for Power Supply/Electronics
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed to move everything closer to the breakout board after upgrading to the BTT SKR 1.4 Turbo mainboard. These…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 306
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed to move everything closer to the breakout board after upgrading to the BTT SKR 1.4 Turbo mainboard. These brackets use some of the M4 holes on the electronics enclosure and power supply to mount everything to the side of the 2040 extrusion.
This design does not provide enough lateral clearance for the X-axis (it must be mounted below the X-axis carriage) but there is enough room for the hotbed to move unimpeded.
This was made for the 2020 version of the PRO. I cannot say if it will work with the 2019 or any other X5SA variants. I've included the .f3d files so you can modify the design to suit your needs.
In the pictures the electronics enclosure bracket suffered a power outage and did not get to finish so you see it without the side bracing that the model includes.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament: Smartbuy ABS Red
Notes:
Used a 0.4mm nozzle, 0.4mm wide, 230C hotend, 100C bed, 36mm/sec, 80% speed outer perimeter. A five perimeter, one layer tall brim was used to eliminate warping. Supports were set to 15% with no dense layers for easier removal.
Category: 3D Printer Parts