Raspberry Pi Zero W case for OctoPi
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a case for a Raspberry Pi Zero W with Camera. The camera module is a cheap chinese clone with the long flatcable.
I tried to use as few metal screws as possible. Everything is printable except the USB connector and the screws for the USB-connector holder. The female type A USB connector I used is from an old computer housing, those type of connectors are also sold on Aliexpress.
Because i made the part for the USB connector separate, it is very easy to make your own for whichever type of connector you want.
The two base parts snap together, no screws needed.
Print Settings
Printer:
CTC i3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Notes:
Only the Camera latch needs supports
I designed the holes for the camera latch to small. I did not want to print it again, so i used a dremel tool to make the pins on the latch a bit thinner.
Category: 3D Printer Accessories