1mm nozzle version of Crazy FAST Voodoo Headband Prusa Faceshield compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE There is a new version: https://www.prusaprinters.org/prints/29052-1mm-voodoo-faceshield-v34
This print uses Voodoo magic and a 1mm nozzle to enhance print speed while still producing a good quality finish.
ATTENTION!!!
These files only slice with Cura 2.4 which is not available anymore. but you can Download my installation from here:
https://we.tl/t-vpmwlS0oSR
Also here are curaprofiles which I highly recomment as a basis:
https://we.tl/t-jUbkrpgmb8
Cura 2.4 is needed for the Voodoo to work. The bug breaking my magic is unfixed for years now but here is all you need to
print face shields crazy fast.
It uses the "surface mode" feature from the experimental section which moves the nozzle on the middle of the surface instead of inside the boundary's of a closed object. With that I have almost full control over the movement of the nozzle. It is my specialty to make models that can be printed in one go without traveling at all. So you can print fast and still have a good finish.
There is also a version for a 0.4mm nozzle:
https://www.prusaprinters.org/prints/28342-crazy-fast-voodoo-headband-prusa-faceshield-compati
The print time for the .4mm nozzle is about 40 minutes and for the 1mm nozzle about 20 minutes
And please take the time to rate and comment
The attached gcode is for a Anet A8 and PETG
If you print in PLA there is gcode for that in the "user print files"
the gcode is for a 1mm nozzle. But I cant select that...
Update V2.0 April 6th 2020
There was a fatal bug in the design wich effected the stability when printing in PLA. if you printed the first version in PLA check your parts. the "flaps" kept breaking off while putting the shield on. PETG parts should be fine. New version is testet with PLA and while PETG is still much more flexible using PLA is now exeptable.
Update V2.2 April 7th 2020
Just rounded an edge and updated the curaprofile a bit.
Print instructions
Layer height: 0.625
line width: 1
outer wall speed: 30
fan: off
surface mode: surface
spiralize outer contour: true
z seam alignment: user specified
z seam x: 100
z seam x: 0