1 / 9
Get the heater out :) Little helper for hotend V6 removal
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will help you to get the heater out of an V6 hotend. A 20 minute print that might save you a lot of trouble.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 405
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (13)Powiązane
I wanted to replace my Prusa Mini hotend with an Dragon hotend. However I was not able to get the heater out of my hotend. So I designed this little helper.
My V6 hotends have slightly different dimensions. It should fit them all, please tell me if not :)
There are two versions:
- Version 1 uses a spare Prusa M3 screw and nut. The nut can be pulled out with a small hex key from the bottom. If you are afraid to damage the heater with the screw, you can also print a small cap for the M3 screw,
- Version 2 uses any M4 screw. No threaded nut is needed.
You can print both Versions with an 0.4 or 0.6 Nozzle. No special setting or support is needed.