Y-Stop Offset for Stepper Damper Upgrade [Ender 3 Pro]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Offsets the y-stop for clearance after adding a motor damper and heat sink
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 488
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This offsets the Y-Stop by 12mm on an Ender 3 Pro to allow clearance for a Stepper Damper and Heat-sink upgrades. Please note that part of the sheet metal mount was Dremel'ed off (visible in cover photo) and 1 additional M3x6 was used to secure it to the cut bracket, but I think it's ultimately unnecessary as the extrusion tab was a nice snug fit.
This is used in conjunction with a smaller rear bed-leveling knob to allow for extra clearance and sacrifice less of the print bed.
Can be printed without supports. Stock Y-Stop screws fit well into the unthreaded mounting holes of the part.