Qidi Tech 1 Foot Extension / Dampener
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted a foot spacer to lift the printer away from the surface slightly (15mm) and provide some dampening / ant-…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 268
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Wanted a foot spacer to lift the printer away from the surface slightly (15mm) and provide some dampening / ant-vibration but not so much the printer would wobble about.
I printed using TPE which has given the perfect result, but TPU or PLA would be just as good I suspect. Although any non-rubber based filaments will reduce to being purely more of a spacer for air flow only, rather than offering any dampening.
Will share my basic settings in the section below as had a lot of trouble printing with TPE until these were dialled in...now printing very well :)
Included the STL file for the spacer, but also the Solidworks files for the original foot fitted to the Qidi Tech 1 in case you need to check you have the same fitted or wish to remix.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.3
Infill:
15%
Filament: Technology Outlet TPE / TPU Black
Notes:
4x Top & Bottom solid layers,
3x Outline Perimeters,
Temps: 70degC Bed, 220degC Nozzle
Print Speed: 70mm/s
I used a single brim layer at 0.4mm offset which peeled away nicely.
Category: 3D Printer Accessories