Sidekick64 Cartridge Case: Lower part optimized for print with less supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the Sidekick64 Cartridge Case by bigby. Lower part is split into two pices for better 3D printability
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 444
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the lower part of the Sidekick64 Cartridge Case by bigby. The bottom part is divided into two parts to avoid supports and thus get a better surface.
The parts can be easily put together without the need for additional screws or glue.
After inserting the boards and closing the case with the upper case part, everything stays in place. This is only the lower part of the case! Upper part can be found here:
https://www.printables.com/de/model/122968-sidekick64-cartridge-case
Please note the license for this design! It does NOT allow for commercial use.
This case is designed to fit version 0.41 of the Sidekick64 cartridge for the Commodore 64 and a Raspberry Pi 3B+.
Additional material required for complete device:
- 4 screws M2.5x20, flat head
- 4 nuts M2.5
- 1 Raspberry Pi 3 B+
- 1 Sidekick64 PCB, assembled
- upper case part
Print Settings
Rafts:
No
Supports:
Not necessarily. I printed my test prints with cheap filament that is not well suited for bridges. With good filament and correct printsettings I think no supports are necessary.
Resolution:
0.2mm
Notes:
Print bigger case part with the outside facing down on the bed.
The small part has to be printed upright.
See Photos.