Tissue Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for toilet tissue based on the leaf soap dish design.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 612
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
My wife really liked the soap dish and wanted a matching toilet paper holder. I remixed the leaf part to grab some brownie points 
There are 2 sets of models which are basically the same. V1 is the whole holder if your printer is big enough to accommodate the print. I'm using the Snapmaker A350 so I had to print in 3 parts (v2) to assemble. No glue is necessary (fits like a glove).
I used 20% infill and it's holding up very steady. The only supports that I used were the two cuts at the tips of the model and the three “extensions” for the screws. The middle “extension” hole at the bottom is really not needed (ended up not using it) as the model is only for lightweight tissues. If you want to use that, you'd probably need an angled bit to fasten a screw in.
Enjoy and post makes!